RL 1200 CARPET WRİNGER CENTRİFUGE

RL 1200 CARPET WRİNGER CENTRİFUGE TECHNİCAL SPECİFİCATİON

RL 1200 TECHNICAL FEATURES

 Voltage                          : 220-380 volt - 50Hz

Motor power                 : 4 Kw – 5,5 HP

Motor speed                  : 1400 d/dk

Drum speed                  : 1200 d/dk

(Soft-start )

İnner drum diameter     : 320 mm

İner drum lenth             : 2500 mm

RL 1200 CARPET WRİNGER CENTRİFUGE USER MANUAL

PURPOSE OF USAGE

This machine is certainly designed for drying carpets. Using this machine for the purposes other than what it is designed for can cause hazardous results.

 INSTALLATION

This machine is delivered fully installed and in perfect working condition.

This machine should be placed on a flat surface.

Before running the machine  please make sure the required working voltage of the machine is suitable to your electrical network.

OPERATION

Carpets should be rolled tightly with both ends equivalent to eachother and placed into the drum in the direction of rotation.(see the Picture) Otherwise due to being unbalanced , machine may start bouncing and cause damages to itself or its surroundings.

After placing the carpet into drum  as stated above, use the green button on the control panel to start the machine and keep it running for 5 to 6 minutes and stop it with the red button.

Wait until the drum complately  stops turning and get the carpet out by opening the door .

WARNINGS

Carpets should be rolled tightly with both ends equivalent to eachother and placed into the drum in the opposite direction of clockwise . Otherwise due to being unbalanced , machine may start bouncing and cause damages to itself and its surroundings .

Please make sure the door is fully closed before running the machine

Opossite sides glued or waterproof rugs should not be dryed in this machine. They need to be dryed with vacuuming.

Do not open the door before the drum complately stops spinning.

Drying each carpet should be done only once.

Short runner rugs should be placed well balanced in the machine.

Carpets that do not fit into machine should not be folded or compressed to fit.

Machine should not be run without a grounding line.

Place the power cord higher from the ground

Do not touch the machine or try to move it while running.

Do not pull from the power cable to unplug

Do not run the machine if the power cord is damaged.

MAINTENANCE

Plese unplug the machine before performing cleaning or maintanence.

Depending on the frequency of use ,lubricate the bearings once a month.

Check the belts once a month ,tighten them if loose.

RL 1200 CARPET WRİNGER CENTRİFUGE VİDEO